Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Farmall 100 change from 6 to
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on July 10, 2003 at 14:32:04 from (64.228.11.125):
In Reply to: Re: Re: Re: Re: Farmall 100 change from 6 to 12 v posted by don on July 10, 2003 at 13:08:46:
Don: That is precicely what I do always run the ground strap to a casting. That old sheet metal just isn't good enough ground. I also go for soldered on ends on my cables and 1 gauge wire. When cables start looking a bit on crappy side after 10 years or so I turf them. Many many good batteries have been wasted because of poor cables. I had lot of starter troubles with a 6.2 Chevy diesel. I went through one a year when truck was new. I moved the batteries side by side and wired it up with 1 gauge same type system as used on highway tractors. The last starter went 6-7 years. Poor power supply very hard on starters. On a 100 hp John Deere, around Christmas was a bit sluggish starting, 12 year old machine, batteries 6 years old. I replaced all cables with heavier than original. Got two more years from batteries, and that machine was being started every day in sub 0 weather with out block heater.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|