Farmall & IHC Tractors Discussion Board |
need an engine guru (HELP)
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by wh on June 01, 2003 at 06:31:48 from (152.163.253.102):
just had an farmall h overhauled at local dealer (top quality dealer). new sleeves,pistons,the works. they sent the head to local shop to be redone. local shop has top quality reputation. had work there in past and allways pleased. now to problem - engine started to smoke severly after about 10 hours of use. local dealer came out , drove it and determined it was oil coming around valves. took it back and took valve cover off. found that there were no seals around valve stems. orded seals and installed them. worked fine for about 10 hours. started to smoke again. extreme amount of smoke - especially after going down an incline. took plugs out and could wipe the oil off them with finger. dealer is going to pick it up soon and go back into it. he is stumpped as to problem. once back into it, it may be obvious. anybody have any ideas? wade
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|