Farmall & IHC Tractors Discussion Board |
Access to front transmission bearing seal....Super A
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave Stoner on November 08, 2002 at 13:53:13 from (205.188.209.78):
I have just acquired my first tractor and find that there is a transmission lub oil leak comming from the seal where the drive shaft enters the front of the transmission. I must now replace this seal. As long as I am at the front of the transmission, I plan to replace the bearing as well. My problem is this: I do not know where to begin or the sequence of dismantleing events I must SAFELY accomplish to gain access to this errant seal. Of course, I know I must break the tractor apart.......but where and how? Would some one with direct experience and knowledge of this operation please email with a contact telephone number and I will call you at your convenience. As an alternative, Please call me collect and we can discuss my dilemma. I would sure appreciate the help. Regards, Dave Stoner
588 Trumbull Court Sunnyvale, CA 94087 408-245-1630
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|