Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: HELP!!! Any Old Timer IH Mechanics, (1952 Cub Transmission)
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Old Dutch on June 24, 2002 at 17:15:05 from (66.191.112.67):
In Reply to: Re: Re: Re: Re: HELP!!! Any Old Timer IH Mechanics, (1952 Cub Transmission) posted by Dave F. on June 23, 2002 at 21:14:07:
Dave, the backlash should be .003 thousandths to .005 thousandths and this you set with a dial indicator. You have to set your tooth contact as you said you did previously, first. At that point you should have a contact area on the ring gear on the pull side that would be contacting the heavy middle convex area of it, pretty much all the tooth from beginning to end. In essence the pinion should when you are looking at it be lined up front edge even with edge of ring gear and rear the same. When you have that, your next step is moving the carrier either toward or away from the pinion till your backlash is in specs. Their should have been shims on bearing for pinion, and also on either carrier bearing. The ones on the carrier are usually transferred side to side, once the preload is set, in this case being no side play.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|