Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Re: HELP!!! Any Old Timer IH Mechanics, (1952 Cub Transmission)
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave F. on June 24, 2002 at 22:53:40 from (64.12.103.183):
In Reply to: Re: Re: Re: Re: Re: HELP!!! Any Old Timer IH Mechanics, (1952 Cub Transmission) posted by Old Dutch on June 24, 2002 at 17:15:05:
Dutch, yes there where shims, for the carrier & I even had to make some extras to get the preload right, the only spacers I can recall on the pinion,(if memory serves me right) are between the gears & pinion bearing? I belive the engagement between the gears where equal, The backlash the rocking (play between 2 gears were propably .005 or little less I don't have an dial indicator. ( I hope I don't appear stupid) I've ask some old mechanics for help they were busy or other wise not interested. Thanks Dave F.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|