Farmall & IHC Tractors Discussion Board |
Re: im not getting power that turns the mag
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by D Slater on June 02, 2007 at 03:47:16 from (72.65.156.125):
In Reply to: im not getting power that turns the mag posted by jonnnny2006 on June 02, 2007 at 00:00:53:
Crankshaft gear turns a idler gear,idler gear turns cam gear the one you can see in hole where you removed mag. drive. Can you roll that gear 360 degrees manualy through mag. drive hole to inspect teeth? Its not very common for a cam gear to fail on those engines. The idler gear runs on bearings that can fail. Injection pump gear drives from idler gear. You could remove cover from front of injection pump gear and see if it turns to narrow problem down, but think the hole front cover will end up being removed in the end. Injection pump may have locked up and caused a gear to fail or lots of other things. Can't remember right now if any of bolts in mag drive mounting will hit cam gear if to long like on gas engine. Like some others said you need a manual.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|