|
Farmall & IHC Tractors Discussion Board |
im not getting power that turns the mag
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jonnnny2006 on June 02, 2007 at 00:00:53 from (67.142.130.18):
What would cause the part where the magneto gets its power from to fail? it is not live hydrolics running off there so there should not of been added stress. i took the mag off my md and was watching the part the mag mates to and when i crank the engine the part that runs the mag doent spin. it will move slightly after 10 full cranks. what would cause this part to fail? It dosent seem like it would be under alot of stress as my kid can turn the mag by hand. the engine is not getting power tothe thing that spins the mag. so if the engine cant turn the peace that turns the mag theres somthing wrong. how should i go about fixing it? any ideas ever had it happen to you before? i knoe one of you guys or gals have seen this condition before.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
