Farmall & IHC Tractors Discussion Board |
FARMALL CUB COMPRESSION
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by NICK D on May 09, 2007 at 03:43:27 from (67.140.34.248):
I bought a 1971 yellow and white Farmall Cub that I am trying to get going to mow some grass. The motor seems down on power even for a Cub. There is a lot of blowby coming out the oil breather/dipstick area and barely has enough power to run the mower. I checked the compression and it has 125 psi in all four cylinders. This seems to me to be in the normal range for compression. The tractor has been sitting for a while. Will this get better or do I need to look for something else? Tuneup? Carb. rebuild? New rings? Will adjusting the valve clearance help power. Any comments appreciated. Thanks
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|