Farmall & IHC Tractors Discussion Board |
Re: M pulling 3 bottom 16 inch?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on April 19, 2007 at 02:37:27 from (216.208.58.155):
In Reply to: Re: M pulling 3 bottom 16 inch? posted by tom43 on April 18, 2007 at 19:59:33:
tom; You best give your M a tune up. An M will pull 3x16 in just about any conditions, as long as it's properly weighted for traction. Now, you may have to plow some soils in 2nd gear, however an M plowing with 3x16 in 2nd gear will plow more acres per day than an M pulling 2x16 in 3rd gear. There is nothing wrong with plowing in 2nd gear, it will reduce your cost of wear parts per acre, by about 40%. I plowed for years in sandy loam with Farmall 300 pulling 3x16, 8"deep, then later a 656 pulling 5x16 same depth. I'm plowing heavy clay these days with 2x12 behind a Farmall 140. I fully realize some of you folks like to plow up in 3rd or 4th gear. I guess that is acceptable if making money is not the objective of farming. Personally I like to make money.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|