Farmall & IHC Tractors Discussion Board |
Re: M pulling 3 bottom 16 inch?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by BOBM25 on April 19, 2007 at 09:05:23 from (69.68.42.16):
In Reply to: Re: M pulling 3 bottom 16 inch? posted by Glenn FitzGerald on April 19, 2007 at 05:12:28:
Or bring it to my little area of NW Ohio. That 3-16's will stop her dead in her tracks. If you got a sweet running bored out M, you MIGHT get by with a 3-14 in 2nd gear. We run a 3-12 behind our M with a new engine (M&W pistons) and a I got a 3-14 fast hitch for the SMDTA. 'Round here most everybody has a 125-150 hp 2wd tractor like a 1086 IH or a 4440 Deere and a 5-16 semi mounted plow to go with it. Someguys go faster than others, but everybody knows that's just how it works. You fellers a couple states over to west just remember us when you hook the same plow to your 560.
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|