Farmall & IHC Tractors Discussion Board |
Re: M pulling 3 bottom 16 inch?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by IndianaRed on April 19, 2007 at 06:15:51 from (64.12.117.8):
In Reply to: Re: M pulling 3 bottom 16 inch? posted by dhermesc on April 19, 2007 at 05:21:56:
I don"t know. My Grandad has been farming in the Kansas Flint Hills, Chase county, all his life. He pulled 2 16"s with his H, and 3 16"s with his M. I"m not a farmer, just want to be, but was bitten by the Red bug about two years ago and have been talking to him about it a lot. They"ve got a 706 and an 826 they use daily, but the M, SH, and H still get worked occaisonlly. I thought the M was marketed as a 3 bottom? Funny side story. He went to buy that Super H about 30 years ago from a guy for I don"t know how much. But there was an M sitting there and the guy wanted to get rid of it, told Grandad he could take it with the SH just to get it out of there. That M has never needed anything, and starts right up and runs great still. Uncled baled 2 cuttings with it last summer when the 826 went down. Best damned tractors ever made.
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|