Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Another Wisconsin H restoration begins


[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by WIRED on October 13, 2001 at 18:54:35 from (169.207.73.165):

I don't know where Mike in southern Wisconsin is, but I'm in southeast Wisconsin and today was the official "kick off" of my 1941 H restoration.

I got as far as getting all the sheet metal off (didn't mess with the gas tank yet), the steering shaft off, and a liberal application of PB Blaster on the nuts holding the radiator on from underneath. Those darn cotter pins were a bear to get off, and I can't get much leverage with a 9/16 box end wrench, so the PB better melt away my troubles!

I'm going to do a frame-off rebuild of the engine and get it done right. The engine isn't stuck, but every gasket on the tractor leaks and needs to be replaced -- especially the rear wheel seals. Aside from the mechanicals, it looks like I'll need to buy a replacement seat, steering wheel, manifold and a whole lotta paint. If there's any money left, I'll do the rear tires -- they're about 60% right now.

This is my first one. I bought the H and a '38 F-20 on Labor Day, and I've been saving my pennies for the first trip to the machine shop. Assuming there's any skin left on my knuckles, I'll tackle the F-20 next year.

Thanks to everyone for the inspiration, whether they knew it or not. I would never have taken on a project like this one without the resources of this forum.

Brett -- A.K.A. "Wisconsin Red"

Thanks for all the inspiration from everyone!


Follow Ups:




Post A Followup

:
:

: Re: Another Wisconsin H restoration begins

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor. ... [Read Article]

Latest Ad: Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy