I plan on doing something similar.. But different..
I'm going to assemble a tractor from a wide array of things I been collecting. It won't technically be a "doodlebug", as I'm starting with a Massey-Harris chassis..
I plan to assemble it, and call it a 33 special diesel. It will be powered by a 2-71 Detroit from a scrapped crawler.
I saved the steer axle, steer cylinder, and steering motor from a scrapped MF 750 combine and I'm going to turn that into my front end. I don't care for how the MH wide fronts really turn, so with the hydraulics, and a different front end, I should have a different turning radius, and easier steering, plus built stronger..
This is all in a quest to have something that is like no other. I plan to invest a lot of time, so it looks almost like something that could have been produced, as opposed to a pile of scrap iron.
The plus side to my project is I have saved all the parts this far from being scrapped. The tractor chassis was headed to the crusher, it was already less a engine, most tinwork, radiator, etc.. I bought the crawler engine from a scrapper, and I scrapped the Massey combine. What tinwork I have collected now was destined for scrap, as it's pretty beat up.. but a little time will straighten it up, and if i have to cut and hack, I'm not ruining any good tin, just what was being discarded from someone else's project.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.