I have a JD 2130 with an Allied 595. The loader goes on or off in about 5 minutes. You set the stands down by pulling and reinserting 2 pins and loosen 2 1 5/16 bolts, undo the four hose quick couplers, and back out. The loader is about 15 yrs old. I like it fine, but some of the new ones are even better. I also have a Kubota M4500DT with a KMW loader that is supposed to be quick attach. The stands don't stay with the loader, so you have to fetch them from wherever they are stored. Also they fit loosely on the loader so that the loader can move side to side alot, enough to damage the tractor. I usually end up holding the Kubota loader in place with the John deere and chains so I can get the Kubota disentangled from it's loader. Needless to say, it only comes off when I have to fix the tractor, which is way too often. It was also built without quick attach bucket, which I think is retarded. I switch from bucket to bale spear and back sometimes 4 or 5 times a day depending on how many pens I need to feed in. I had a neighbour change it to the same system as the allied loader so I can switch buckets and manure and bale forks between tractors.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.