Posted by Jon Hagen on December 15, 2010 at 07:52:27 from (69.26.23.96):
In Reply to: 856 help pls posted by deerepower on December 15, 2010 at 05:36:03:
I am in the last stages of rebuilding an 856, also my first IH of that series. Mine had similar problems with the transmission. First thing would be to remove the cowl sheetmetal and inspect the shift linkage bushings. There are a couple of bushings mounted in sheetmetal brackets in the upper cowl area that break up and cause sloppy shift linkage.
Also with the floor plate removed, remove the range trans (rear transmission cover) shift linkage and shift the lever through L-N-H. The lever should have a distinct snap into each gear, otherwise the shift detent parts on the underside of the cover may be worn or broken as mine were. (common problem on that model.)
New shift detent parts are pretty pricy, but I found excellent ones at a salvage yard for 20% of new.
I also rebuilt the shift detents in the range trans,(under the steering pedistal).
Not that hard to work on and now a real joy to shift.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.