Posted by RodInNS on November 23, 2010 at 09:57:57 from (216.118.158.123):
In Reply to: 3000 ford diesel posted by Randie on November 22, 2010 at 20:21:43:
Check that the ground stud on the end of the starter is tight in the brush holder. Tighten the jamb nut if necessary. Same with the pos stud on the solenoid. Clean them. Clean the cable connections. If you have the clamp on cable ends... get rid of them and SOLDER on NEW crimp style ends... provided that the cables are good and don't seem to have broken strands. You also want to make sure that you have a minimum of 2/0 cables and the proper 4DLT battery doesn't hurt, particularly if it's cold.... If that doesn't solve the problem then the humble Lucas probably needs a new set of brushes and a new end bushing. Pretty basic maintenance on those things... and it's good to go for another 3000 hours. Just because it spins up fine on the bench doesn't mean the brushes are good...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.