Posted by Scott in PA on November 18, 2010 at 14:56:10 from (174.55.164.55):
In Reply to: Engine Block Repair posted by Scott in PA on November 17, 2010 at 20:22:22:
I welded the block of the Kohler engine in my old JD 214 garden tractor with my MIG using standard .035 steel wire. It lasted several years until the connecting rod went a second time, hitting the exact same spot. I had had enough on JD"s by this time and sold it for parts and started using a old beat up Murray that a friend had given me. It cut circles around the JD.
Anyway, I found a posting on smokstak.com about using a special cast iron MIG wire from http://www.crownalloys.com/products.php.
I also read a few postings about doing the stitch method with brass screws. Is this a viable option or are the pins at locknstitch.com that much better? I have a huge drawer of brass bolts so my cost would only be time. locknstitch isn"t listing pricing on their site but they do mention that the kits can cost from $100 to $8000.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.