Posted by george md on November 18, 2010 at 09:22:25 from (209.213.167.201):
In Reply to: Engine Block Repair posted by Scott in PA on November 17, 2010 at 20:22:22:
Scott,
That crack will go all the way thru, cast does not bend ,it breaks except in very thin sections. Second note ,if you weld it with any kind of arc, the area around the weld will be so hard that it is almost impossible to machine. The weld may be soft ,but the fusion zone will be extremely hard. It does that because the rapid temp drop between the arc temp and the surrounding cool material. To get rid of the hard spots ,you need to heat the casting to about 1500 deg and hold for 15 to 20 minutes to normalize, then it will be machineable.
As stated below ,you best repair would be the locknstitch products , they work much better than the old irontite pins .I used the old ones for years, but have changed to the locknstitch for almost every thing, and will be very machineable after installation.I do a fair amount of cast repair.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.