Posted by Kentb of SWMO on June 11, 2010 at 06:14:25 from (98.20.113.12):
In Reply to: electrical help !!!! posted by randy47 on June 11, 2010 at 05:10:56:
First is the D.C. motor you want to control/reverse a permanent magnet D.C. motor? Next by a six pole switch, do you mean a switch that has six terminals? If the switch has six terminals it should be a DPDT ( Double Pole/ Double Throw ) center OFF switch. If all of this is correct, hold the switch so you have two vertical rows of three terminals. To wire the switch, connect a red wire to one of the two center terminals. Connect a black wire to the other center terminal. These will connect to the battery. There should be a fuse or a circuit breaker in the red wire. Next connect a wire from the lower left terminal to the upper right terminal and leave what ever length on this wire to connect to one terminal of the motor. Now take another wire and connect from the lower right to the upper left terminal of the switch and again leave what ever length of wire to connect to the motor. You should have these two wires making an X on the back of the switch. NOTE: If the motor you are trying to control is a series wound D.C. Motor THIS WILL NOT WORK. You have to do it another way. I do this with Chrysler gear reduction starter motor to make them winch motors. If this is still CLEAR AS MUD, send me an E-mail and I will send you my Phone Number where we can talk.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
