Tractor Talk Discussion Board |
Re: Re: Re: Homemade fenders?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by rhudson on June 07, 2001 at 20:52:19 from (63.124.154.5):
In Reply to: Re: Re: Homemade fenders? posted by Adam on June 07, 2001 at 08:41:05:
Adam, if you would like, email me and i'll send you a sketch.(i think i know how to use the scanner). i agree with the other post, building is not for everyone. the fact is that the average person knew more about metalwork a 100 years ago than the average person does today. if i had to guess, i would say 1 in 5000 have really good metal working skills. i'm not saying i'm that one. but i have worked under some very skilled machinest and fabricators. i have a pull type 1.5 yard scraper (pan, scoop) that was built by an individual. i would say it is the best operating pan i have ever used. if you want to build, enjoy building, have time, tools and materials to build. then build and build it right. i'll get off my soap box now (one of my jobs is to foster craftsmanship, so i take kinda personal)
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|