Tractor Talk Discussion Board |
Re: Re: Homemade fenders?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Adam on June 07, 2001 at 08:41:05 from (209.115.44.6):
In Reply to: Re: Homemade fenders? posted by Grove r on June 07, 2001 at 06:37:22:
I am not to bad working with sheetmetal. I just recently relined the left floor board of a rusty 85' Dodge pickup with some gal. sheetmetal. I have a good old pair of Milwaukee electric shears that make cutting it very fast. I have plenty of scrap sheetmetal, angle, pipe etc. of many sizes and thicknesses, some stainless(wouldn't that be the talk of the town-stainless fenders, probaly not) laying around I got free for scrap, so the metal won't cost me a dime. I probaly will recess the flasher and tail lights under the fenders. My Uncle has a sheetmetal break I could borrow to make the job easier. Thanks for the input.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|