I am not about to dispute anything you have said here, as I think your advice is right on. But as I recall, Lance is about to acquire an S10 frame, which I think (but not sure) is pretty thin metal, maybe 14 gauge. And I think the frame is box section or maybe box section and flange section hybrid. I have welded on Corvette frames (rust replacement sections just forward of the rear axle) and frame repair on our old Loadstar 1600 grain truck. At the experience level I now have (repair farm welding 50 years), I can do a satisfactory job on either. But Lance is new to this and 7018 is a bugger to strike an arc with if you have no experience. It is also one of the easiest rods to burn through thin metal making big holes probably not repairable with his level of experience. I have been a welding instructor for our new guys in our Blacksmith Guild. I can teach them to be basic welders in 8 hours, but I start them with 6013 flat position, then step up to 6011 (flat) in rough and rusty steel, and then finally teach them to use 7018 in high carbon steel. And if Lance has no arc welding experience, I recommend that he follow the same progression of rods on practice metal before he welds frame.
He should also know that heating up the 7018 rods for a few hours will make them easier to use and give better results. Make a rod oven, or use a heat lamp (or use Mom's oven set on low, if she is not home). This is much less of a problem if the rods are brand new, but if they have been hanging around the shop for a few months or years, they absorb moisture from the air and can get pretty ornery.
If he can't find any old timer like you or me to help him get started, them maybe he can look up (internet) his closest ABANA chapter and ask for some old timer to give him a few hours of hands-on welding instruction (may even be no cost....I have done this a few times for young guys).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
