Tractor Talk Discussion Board |
Re: Re: 3 Point Hitch Hydraulics - Moving Heavy Clay with Blade
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Glen 7580 on May 30, 2001 at 17:58:11 from (209.90.134.176):
In Reply to: Re: 3 Point Hitch Hydraulics - Moving Heavy Clay with Blade posted by Joe Evans on May 29, 2001 at 20:42:03:
Re: "You have a lack of down pressure on the 3 pt lift arms. The aggregate weight of the blade, its frame, and the tractor 3 pt linkage is all that's holding the blade in the cut." I suspect that something is wrong with the Hydraulics (a valve hanging up or leaking by). I don't have a lot of weight that I could hang on the blade and I suspect that I would need a lot. I will give the weight approach a try a little later if I can't do better with the hydraulics. Thanks for your input.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|