Tractor Talk Discussion Board |
Re: Re: Re: Re: 3 Point Hitch Hydraulics - Moving Heavy Clay with Blade
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Chris on June 01, 2001 at 21:52:19 from (65.81.120.3):
In Reply to: Re: Re: Re: 3 Point Hitch Hydraulics - Moving Heavy Clay with Blade posted by paul on May 31, 2001 at 00:04:45:
I tried to explain it earlier myself Paul, If it is set in position control that's as good as that tractor is going to do. From reading the continuing discussion I think the feeling is the hitch while not pushing down should be holding it down but as you and I have said it isn't so. Perhaps a ripper could be used to break up the soil in the area before trying to move it with the blade as it would be easier for the blade to move then. Also like I said down pressure is a nice thing about a Farmall but the Farmall system does lack one thing the others have--float. I'm putting a 3pt hitch on my Allis B and I am using a double acting cylinder and a loader valve so I can get downpressure and float.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|