IHMANKY said: (quoted from post at 22:55:24 04/04/10) Frost-free hydrant by farrowing house has cracked, and we've spent countless hours prodding around, searching with a metal detector, and reminiscing about where this old water line ran exactly, but still no luck. It's deep enough under the lane that we don't care to dig, because the shutoff is somewhere between there and about 40 yards up, and if we try it with a trackhoe, we'll cause more problems than we got. Simple thing is, if we can break the line just before the hydrant, and glue on another valve in between the line and hydrant. My question is, is there a pipe glue for pvc that will adhere when applied wet? The line is gravity fed, around a 30 foot drop so talking 15 psi or less. If we could "wet glue" the line side, we could always close the valve and dry glue the hydrant side. Anyone glued wet pipe with any success before, and if so, what's the product?
Just use a screw type compression fitting & be done with it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.