Posted by Dave Sherburne NY on February 20, 2010 at 13:52:20 from (74.39.163.223):
Decide to change the sloppy idler arm today. It has the tapered joint that fits in the "drag link" I think its called. And the other end is about a 6" piece with two holes that bolt to the frame. This piece has an offset built in that changes the center to center pivot point about 2 inches. I think the one I took off was put on wrong. The pivots in the drag link are about 17 1/4" center to center, With the drag link the way it was, the idler arm pivot at the end of the offset arm and the one on the steering gear are about 18 3/4"C-C.Plus, the bend in the idler arm is causing wear on the frame. Question, should the pivot points on the drag link and the center to center at the end of the Idler arm bracket and the steering gear pivot be the same. Hope you can understand this question, its hard for me too.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.