Also I dont know why I didnt think of this before but if you dont need that shaft,with a good torch and the right tip you could burn the shaft out of the hub.Might not even need to burn all of it out,just enough to break it loose.Just trim it down as much as you can and burn into it.It may be a little hard to keep it straight but you can do it.If its too far for your torch to reach,turn it over and burn it the other way until you get a hole through it in the middle.Then you might be able to blast all the way from one side.Whittle it down and try it once in a while once you get a piece out.Stay off of the hub with the torch,just burn the shaft only.It can be done. If you arent good with a torch and have the shaft real hot before you get a hole in it,better let it cool off and then it might come out anyway. It can be welded probably and hold.I would use 7018 and v it out first.Run a pass,clean all the slag off,run another pass clean all the slag off and keep doing this until you get the V filled.Go to the other side and grind down until you get through any slag down to weld and weld that side out the same way.Since none of those welds would be an inch long or much more you can weld them one after another without stopping.You cant stop until you get done welding either because it might crack if you went and ate lunch came back and started up again.Cast doesnt like that very much.This is assuming you can run 7018 rod.If not practice until you can or get somebody that can weld to do it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
