I had a Case, model C, from the 30"s, and put a front mounted snowplow on it. I put a 2 belt pulley on the generator, and ran a small hyd. pump off that. I calculated 800 psi and 5 gpm to lift 2, 3 inch bore hyd cylinders. Belt did"nt slip. I mounted a 3 gallon tank along side the tractor in some implement mounting slots.Enough oil for cold weather work..it never got hot. because I was plowing in Wisconsin cold I used ATF for fluid. I mounted a small, 3/8 inch ported valve where I could reach it, and plumbed with 3/8 single braid hose,(Aeroquip FC-300) and used a 3/4 inch ID suction line, so as not to starve the pump when oil was cold. You had to be like a Monkey, however, in order to steer, work the Case hand clutch, and the Hyd. valve. I later moved the same set up to a Case DC, but drove the same pump from an extension thru the front crank hole off an adapter from the crankshaft pulley.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.