The inner bearings on this machine are oil lube from the case. The outers are grease lubricated and sealed FROM the inners. The way these are set up, twine never gets at the seal. The seal is actually fastened to the shaft and the wear liner is fixed to the axle housing. It's just a matter of not getting enough lube... then the outer bearing starts getting slack, then the minimal preload is gone... and when that's gone a tapered bearing is not long for the world. From speaking with the dealer pars manager... I seem to be the only one who has these problems. I'm about the only one that ever needs axle repair kits anyhow as he doesn't move enough of them to bother stocking them... I've often toyed with putting grease tubes on so I don't have to pull the wheels to grease the bearings but always worried about the chains ripping the tubes off. Catch 22...
Re: Frame cracks. I've seen cracking in the first gen booms on the 'old' L series machines. The Lx series had a vastly heavier boom with a better design. Granted I haven't looked at a lot of any of them, I haven't seen any cracking in the Lx or the LS yet. Certainly mine has no cracks... and if there was one that should crack, this would be the one. I would tend to think that this boom will probably outlast a lot of others because it has quite large bearing points on all of it's pivots. There's a lot of area to wear. Conventional booms have smaller pin areas that can wear more quickly. I used to worry about all the moving parts in this boom, but aside from the bucket/adapter plate the main boom is as tight today as it ever was... It's certainly got far less wear in 4000 hours than the very conventional loader arms on our loader tractor... with the same hours. The tractor loader has had just about every buching rewelded back into the arms, the arms welded several times, etc. So I'm not terribly sold on 'conventional' loader arms any more.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
