Alright that sounds like a cable problem.If you had a solid 12 volts when you crank it,thats fine.There might be a clutch switch or a oil pressure switch that has gone bad not letting it start?If when you crank it and it has about 11 volts at the starter it should crank.If you have at least that much to the hot side of the starter then it about has to be a ground.The big trucks I know about have a spacer where it bolts to the flywheel housing.Maybe you need to pull that spacer out and clean it and the flywheel housing and the grounding surface on the starter.Try and crank it by jumping it.It should crank then.Actually you should be able to crank it while its off of the truck with the battery charger or a hot battery.You hook the ground to the case and hot to the hot and jump to the switch post on the solenoid.If it works that way it has to be a cable or some switch that wont let it crank.Seems like I remember some over crank sensor on the side of a starter that wont let you crank if you crank over 2 minutes.If it has that then you might have to hook a jumper wire on it to get that to crank.Ask somebody at Freightliner and maybe they can tell you.All big starters have a problem with that brass strip between the solenoid and the starter housing being loose or corroded.Might want to pull it off and see if its in good shape and tight.Also if you changed the starter but used the old solenoid it could be that.Solenoids usually wear out before the starter.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.