Posted by caleb on November 21, 2009 at 17:20:49 from (64.196.35.67):
IA Gary, bill and others thanks for the ideas. As of right now we have been to: The Machine Shed; great food average service, Harris pizza; best pizza Ive ever had in my life good service, Whiteys ice cream; good stuff, and in an hour we are going on a date to Johnnys. As for fun stuff we did the combine tour Friday after my interviews, it was fun but not enough for me! As part of my interviews I got to eat and tour the world headquarters and that was a neat place. Today we went to Lock 15 and as we were talking with the visitor center guys a boat from across the river asked to come through. So of course we waited and watched him come through the lock, the bridge turned and it was a really cool thing to see. Then after that we headed over to the arsenal museum and that was a really neat place. If you like guns youll like that place. The history is what I liked most about it. Just a little while ago we went down for the lighting of the commons and what a neat time that was. All the families out there, the free cider and hot chocolate and the fireworks. My one complaint: what idiot didnt think that when they were naming roads to not have the numbers going four directions. Man Im really good with navigating but not here. I was on 16th and then bam Im on 14th, never turned or anything. I now know the its because the city limits but geez I was lost for a while.
Okay enough for now but thanks a bunch for all the advice. We really have enjoyed the area.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
