Posted by JohnKamerer on September 30, 2009 at 22:04:55 from (98.125.238.218):
I pick up a 1950 8N w/sidemount distributor. Had it running at different times, but with lots of back firing. Then decided to tear it down and restore it. Now iI have it looking good and it won't start. Did do a 12v convert. (get all my stuff from YT) Have great spark (will jump a 3/16 gap bright blue) Pulled head off - brought piston up to TDC - both valves closed and have marks on flywheel set to 4*. Set Distributor rotor on #1 plug. Wires are rotaring 1-2-4-3 CCW. Now the bad news I can't even get a back fire. Carb has been taken apart many times to make sure I have fuel passing through. Seems like I don't have a lot of suction at the carb throat and plugs don't seen wet. Any Ideas? Jk
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.