Posted by Amo in Nebraska on July 16, 2009 at 17:54:03 from (74.85.118.39):
Putting the steering worm gear back in its place. Never removed the race clear deep inside and now putting it back together. The first bearing I put in and got it within 3/8" inch maybe less and thought let the bolts pull it on in. Anyway got the end cap on and tight. Went to drive it and it was 10 times harder to stear than before. Pulled it out and rollers fell out of bearing. So Got new bearing and putting it back in and same problem. Got so close and no cigar. I shove it in the hole and then screw the worm gear into the other gear untill the tires start to turn. Then I quit. As Im writting this I just thought where this dont have power steering I guess the wheels could turn all the way or I could start with them at a different angle I guess. Was just picking brains here Ive never done this before so wondering what I screwed up I guess. Got the right bearing ... sure look the same. #'s crossed over. Old one was Bower 5578 or 15578 and the new one is 15578.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.