Posted by shawnspeed3 on June 11, 2009 at 17:24:23 from (75.218.112.211):
In Reply to: OT Welding Question posted by super99 on June 11, 2009 at 16:59:36:
you are going to need some 6011 electrode for that....and I would also reccomend doing an up weld vs the down....the down will have poor penatration and that bracket needs all the penatration it can get. clean both surfaces of the joint with your grinder & tack in place..then starting at the bottom , start your weld, and when the deposit starts sagging , pull the electrode off to the right, pause, let the puddle freeze, go back in start your puddle again then pull off to the left when it starts sagging again, pause , back in (all without extenguishing the arc)...it sort of helps to count, start the arc , get the puddle 123, sag whip to the right 456, back in the puddle 123, sag , whip to the left 456, back in the puddle..you will find a rythem when all is right. you may also need a little more amperage then you would think, I would suggest at least 125 amps with 1/8 6011, and probbably wouldn't be afraid of more...I hope this helps, it helped me get thru my vertical welding in school....Shawn
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
