Diesels are pretty simple. To run they need air and fuel at the right time. Yours sounds like it's not getting fuel to the injectors.
I don't know about an electric fuel cut off but you are apparently not getting fuel. You could have a clogged strainer at the fuel tank outlet, a clogged filter or an air leak in the fuel supply line. I'm assuming you have a a gravity feed system and not a lift pump to supply fuel to the filter(s) and injection pump. Remove the line going to the filter and see if you have fuel there. If you don't the tank outlet is clogged. You need to clean the tank screen and the tank most likely. If you do have fuel there, reconnect the line and check for fuel at the downstream side of the filter(s). If there's no fuel there your filters are clogged. This fix is obvious. Make sure you bleed the air out of the lines when you replace the filter(s) and then bleed the injectors to get all the air out of the lines. It should start when you get fuel to the injectors.
If you have fuel downstream of the filters then I'd suspect you have a loose fuel connection somewhere between the tank and the injection pump that's causing the pump to suck air. Make sure there are no cracks in the line or loose and/or damaged fittings.
Don't go worrying about the injectors. Yes they can be cleaned and rebuilt in most cases but they don't all fail at once and the failure modes are more subtle than the engine just stopping.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
