You're far more complimentary than I deserve, but thank you.
I can do a little checking over the next couple of days. I can think of one guy in particular that MIGHT have them, but he's tearin' up ground and planting just now. I'll see if I can get hold of him.
Findin' them would be a REAL lucky break. Can't say that I've ever happened across any.
They're really just hardware items -- some 5/16" rod with left-hand threads at the rear of the front one and right-hand at the front of the rear rod, a coupling to adjust them and a jam nut on each end of the coupling. The LH thread for the front jam nut might take a little searching, as would a LH die to thread the end of the front rod (machine shop could probably do that part for you), but it wouldn't be a hard thing to fab up.
If you'd like, my email is open, gimme a shout. I can measure up the one on my SuperC. It looks entirely different at the front end in the parts books from the one for the SuperA, probably because the SC has the steering shaft running down the left side. But if you'd like I can tell you how it's routed and put together a little drawing with some dimensions if you think it'd be helpful.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.