Posted by Nancy Howell on April 14, 2009 at 04:13:38 from (75.30.130.79):
Found this on msn.com this a.m. Not terribly informative, but still interesting.
Open Sea SnipingHow hard is it to shoot someone in a lifeboat 100 feet away? By Brian PalmerPosted Monday, April 13, 2009, at 5:25 PM ET
How does a sniper operate on the high seas? Navy snipers killed three Somali pirates who had been holding an American hostage in an 18-foot lifeboat on Sunday. The SEALs fired from a Navy destroyer 100 feet from the pirates. Can a sniper reliably hit a human target on a small boat bobbing on the ocean, or were they taking a chance with the hostage's life?
If the pirates' heads were fully exposed, it would have been an easy shot. A sniper rifle is accurate to within a "minute of angle," provided the shooter can keep his or her target in the crosshairs. That means that a good marksman can reliably hit a 1-inch target at 300 feet and reliably kill someone at 3,000 feet. The bobbing of the lifeboat would have been a factor, but snipers regularly shoot at moving targets from moving vehicles. (Advanced Navy SEAL training includes target practice from helicopters.)
There are two techniques for hitting a moving target—trapping, in which the sniper holds the rifle still and waits for the target to move into the sight, and tracking, in which the sniper moves the rifle to keep the target in the sight. Trapping is the easier method and is preferred among less-experienced marksmen. However, the Navy snipers needed to strike all three pirates simultaneously. Once the countdown began, they could not allow their target to drop from their sight and wait for him to return. (Sniper teams generally count down from five and fire in unison on the T in "two.")
The snipers had other challenges. First, they had to remain stealthy. If the pirates had noticed that gunmen were lying on the destroyer's fantail waiting to pick them off, they never would have exposed themselves to fire. During the day, the SEALs likely used nylon netting to keep themselves in the shadows. Second, they were a little too close for standard sniping tools. Because the barrel of a rifle sits a couple of inches below the sight, it's angled slightly upward. The center of the sight shows the spot the bullet will hit at 300 feet. At a little more than 100 feet, the SEALs would have had to compensate by aiming slightly above their targets. Finally, the SEALs were shooting from a tall destroyer into a tiny lifeboat, and shooting downward is difficult. A sniper rifle rests on a bipod, and the butt rests on the sniper's shoulder. In order to aim below the level of the bipod, the sniper has to prop his chest up. This can create some instability if it's not done properly.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
