B & D , Back a few years when I was a bit younger and somewhere in the middle 1950's ,I pulled a JD Killefer 20 A ( a single shank on steel wheels) with a Cletrac crawler . It would handle it to about 20 inches ,later years I bought a 730 case and it would handle it to about 18 ,then would run out of traction. The 20A had an extra long shank from a large IH tool bar model and could go well past 24 in , but needed two tractors or cletrac and 730. I did drain lines for the milkhouse wash water with both tractors on it with the mole attached. I also drained wet areas that tractor would not go thru by using long cable across soft and steering with a snatch block on the cable and another long cable cross ways to another tractor. Always start at the lowest point(a large dug hole or a creek bank) and travel up the grade , then the water will run out the low point. 20 A was built in the 40's ,it was adj depth and was ground drive lift for the wheels.I still have it and one of my customers used it last fall to drain some low land. I think you may need some more tractor to pull yours, from the literature for the 20 A suggested HP is near 80hp and with mole or wings add some more and by all means put some fluid in the tires . he he
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.