Posted by fixerupper on March 12, 2009 at 19:05:44 from (66.43.238.99):
In Reply to: The allis drives now posted by Lanse on March 12, 2009 at 17:38:22:
Keep up the good work, Lanse. As Brian said, the 40 grit is a bit severe. It removes a lot of stuff in a hurry but the scratches it leaves behind will stand out like a sore thumb after you spray the paint. Some 180 (or something close)wet sandpaper dipped in water will do wonders for removing the scratches. You can sand away with one sheet for a long time if you keep it wet and it'll remove a lot more material than you realize. If the sheetmetal isn't too rough forget the 40 and just use the wet, it'll remove a lot more paint than you realize. Warm water will keep your hands warm. Now if you're REALLY patient, some 2000 grit wet after the 180 will make her shine like a million bucks. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.