Posted by Mike (WA) on March 01, 2009 at 09:13:53 from (69.10.199.245):
In Reply to: Re: Treated plywood posted by Iowa corn and hogs on March 01, 2009 at 07:48:16:
Yeah, treated plywood is the way to go. I finally re-did the bottom of mine after the wife commented that if that thing got any more holes in the bottom, I wouldn't even have to turn on the beaters- just let the stuff fall out the bottom. I had to get a 10 foot piece, because the thing was 8' 9" long, so it was pretty spendy- but pretty easy to do- broke out the rotten wood with a 3 pound hammer, ground off the rivets, measured and cut the plywood and laid it in, then get underneath and drill the holes through the original rivet holes, bolt it down with carriage bolts and lock nuts. Tip- do 2 or 3 holes first and install the bolts, so it won't move around while you're drilling the rest.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.