blinwmi said: (quoted from post at 00:09:53 02/14/09) Yea, I hear shin used around here too some. Is the landside the piece at the back of the bottom that forms the furrow?
:) The "landside" is the long piece on the left side (assuming the plow turns the soil to the right) of the "bottom" that runs against the unplowed ground and keeps the "bottom" from being pushed to the left! Here's some more terminology!
Bottom = the plow unit, which consists of:
Beam = the curved or trussed bar that holds the
Frog = which has the following attached to it:
Share = the cutting edge that cuts the bottom of the furrow
Point = sometimes added to lead point of the share
Moldboard = long curved piece that actually rolls the soil over
Moldboard extension = extension to the outer end of moldboard, helps prevent the furrow slice from rolling back
Trash board = mini moldboard above shin to help cover rank vegetation
Shin = vertical cutting edge ahead of the moldboard cuts vertical edge of the furrow
Landside = as described above
Heel = wear piece sometimes attached to outer end of landside
Much of this information was taken from one of the operators manuals for JD moldboard plows, thanks John Deere. :roll: If you find any errors or omissions, don't blame me, blame JD! :shock: :roll: :lol: :lol:
There are a bunch more parts that are attached to various places on the plow units such as coulters, root cutters, trip bottoms, auto re-set bottoms, etc, but that's another topic for another day, and perhaps another poster :roll: :lol:
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.