Kevin (FL) said: (quoted from post at 15:56:11 02/10/09) Looking to replace the 24 inch bar on our Husky 395XP. Got it back from the "loanee" and it now has a bend in it that causes the bar to drift to one side and then jams halfway through the cut. Anyway, I'm familiar with Oregon bars but came across two brands I've never used before--"GB" & "Windsor". The GB brand is cheap, so I assume its imported. Anyone have any field experience with either of these brands?
:) Oregon, Windsor or OEM Husqvarna will prolly all be within a buck or two of each other, and of similar quality! :shock: i would agree with the others in that it's most likely the chain not the bar that's causing the dishing! :o The simplest fix is prolly a new chain, unless you're good with a file! :roll: If you have a second chain, throw it on and see if the problem goes away. :wink:
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.