Posted by John B. on January 09, 2009 at 21:31:50 from (38.114.64.141):
Today at work a young man was using a torch to heat up a pin on a bulldozer. The pin was actually the hinge pin for the loader. He was trying to get it out to take the boom/loader arms off of the dozer. As he heated the pin he didn't realize there was a grease fitting facing him. Well he kept heating it and as it smoked and built pressure internally from the grease boiling and the fitting getting read hot, it finally blew out the little ball from the grease fitting like a bullet. Luckily he wasn't in front of it. It flew 30 feet then stuck in the wall of the shop. The grease fitting turned into a 6 ft flame thrower until it ran out of grease to shoot. This could of been fatal.
Years ago I had a friend who was heating up a stell wheel on an old plow trying to take it off. same thing happened to him but he got hit from a chunk of metal that busted off from the pressure hitting him between the legs. He said he swelled up like a melon then had to have one of two private parts taken off.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
