Posted by doug in illinois on January 02, 2009 at 21:55:41 from (207.144.232.74):
I am buying this little 5 acre patch contract for deed, living in a 14x70 1985 mobile home. Barn is over 100 years old with lean to's attached. Anyhow, I can't get insurance anymore, trailer and barn are both too old. Barn itself OK, but lean to's need to go. 15 years is the oldest a trailer can be written, never mind we have updated a lot in it. By the time I get a new enuf trailer and all the changes to the barn I am looking at about 50K. I am also still going thru a battle with the road commissioner regarding drainage problems because he won't put a new culvert under the township road, would rather just leave me with one driveway instead of my circle drive and let the water run in front of the house, in effect shutting off access to the barn and pasture unless I spend the money to culvert it myself. With what I still owe and the money I will need to spend I think an existing stick built home may be cheaper in the long run. Won't elaborate on possible houses except to say I can buy 7.63 acres with a 3296 square ft house and steel building, or 40 acres with two Morton type buildings for only about $200 a month more. If I went the 40 acres I would need to possibly move a house there, it is currently a Morton with living quarters and the wife says she won't live that way. DOUG
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
