Posted by Frank B. on August 26, 2008 at 15:18:56 from (144.226.230.36):
Anyone had experience with hooking an older model Ferguson 3 pt. two bottom 12" plow probably in the 1940"s year, to a Ford 861 Power Master? What I found were two things for which someone's expert commentary would be appreciated:
1. The lift pins on the Ferguson plow are original but are two short to accomodate both the lift arm and sway bar from the tractor. Is this normal? Only way to accomodate is cut off the original lift pin on the plow and weld longer pins. 2. Second problem I encounted was the front coulter of the plow sits so close to the PTO shaft there is only about 1/2" clearance. The coulter cannot be moved back as they are not adjustable. In my opinion this is too close and my conclusion is this plow does not fit this tractor but I thought most any older model 3 point plow would fit a Ford tractor as long as the plow was a 3 point vintage product.
Anyone have an experience like this or know for sure if this plow should fit or not? Thanks for any help or advise.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.