Posted by RobMD on June 15, 2008 at 10:59:31 from (205.188.117.74):
In Reply to: JD 720/730 posted by Eugene SWIA on June 15, 2008 at 10:00:06:
Yes there was a change after 720 serial # 7216900 involving the 5TH GEAr ONLY. These tractors used the R20068R shift quadrant, and were STANDARD EQUIPMENT after 7216900.
You had the **OPTION** OF CONVERTING AN OLDER TRACTOR PRIOR TO 7216900 to the special 8 mph fifth gear and/or a special combo of 4 3/4 mph fourth and 12 1/4 mph sixth gear.
The special 4th and 6th gear was used with both quadrants listed and THROUGHOUT ALL 720/730 tractors.
The special 5th gear shaft was used with the R20068R shift quadrant... I suspect your tractor HAS NOT received this quadrant when they did the 5th gear changeover.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
