Posted by Lanse on May 03, 2008 at 18:46:17 from (64.12.117.74):
"Good, i finally found a crankshaft that'll work"
I took in my old crankshaft to the local head and block shop and they measured it. The man said it had allready been taken 30 under, and worn way beyond that, and unless i could find 40 bearings, i needed a new crank. We then headed up to the next few towns over for the right bearings and some other salvege parts, and another crank. Got everything there and then stopped at an auto parts store for a piston ring compressor, some oil and filters, fuel line, new oil gauge, new water temorature gauge, new muffler, and plug wires. Then i got home and started putting everything back together. Got the crank in and torqued with the bearings, then Tried to get the flywheel on the crankshaft. It wouldnt go, so i stood the engine up and discovered that this crankshaft and flywheel had the holes in differet places. I have a 1939 tractor and flywheel, and not crankshaft. Real Nice. So i am now looking for another AC B flywheel, and a thermostat (mine is srtipped from removing the remains of the last gauge). My question is, do i need a new clutch also??? Im allready looking for a new flywheel not off a 1939 model (anything else) , Lanselot1993@aol.com if anyones got one. I stand by that it'll be worth it if i can pull it off
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
