Believe what you like but I don't see how either of those toys will do any good. As mentioned below already, if you saw an increase from using a K&N filter, then the old filter was already plugged... but I don't see how you would even see an increase because of a plugged filter on a modern engine. Most all gasoline engines today use a MAF sensor or Mass AirFlow, so it measures the total volume of air going into the engine and then computes the injector firing time based on that data. If you have a plugged filter or some other gadget stuck into the intake system, the MAF or MAP sensor will account for it... and then fire the appropriate amount of fuel. From what I saw on the cyclone website regarding mileage claims.... they basically only tested an old carburated engine or at best a throttle body injected engine with a more primitive control system, so mabey there was some gain there... but I doubt you would see any gain on a tune port/multi port injected engine.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.