Posted by Raleigh on March 01, 2008 at 22:58:23 from (68.209.136.14):
OK I Cranked up the tractor for the first time in 6 months. Here is what I have found out about my three point, rockshaft problem. When the tractor is running, and when I start raising the lever for the rockshaft. It is not until I get the lever CLEAR to the top that the Rockshaft even starts moves. Then when it does move, it also goes clear to the top!! When I start lowering the lever form the top, the rock shaft then goes clear to the bottom (ground).
When the rockshaft is traveling from the ground to the top, I can here the engine carrying the load until it gets to the top and then the engine sound like it does not have a load and the rockshaft and implement is at the top.(Sounds like Normal Operation)
I am certain the problem is in the Rockshaft Control Valve housing, but where...I am certain the problem is NOT that the Rockshaft cylinder needs packing. It has to be in the Control valve somewhere.. Could anyone shed some light as to what I could do next? I have taken the Control Valve housing off the tractor, I am still a somewhat baffeld as to what could be going on...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
