Tractor Talk Discussion Board |
Re: Re: Re: Re: Braze a Block or Weld?
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by Russ on December 15, 1999 at 18:43:32 from (148.183.75.63):
In Reply to: Re: Re: Re: Braze a Block or Weld? posted by Burrhead on December 15, 1999 at 17:02:39:
Maybe I`m wrong, but I disagree with Your opinion about not needing preheat for strength. The idea of preheat and post heat is to minimize the "heat affected zone" or HAZ. With arc welding you get some pretty intense localized heating of the material being heated. This causes changes to the granular structure of the metal and induces stress to the part, normally on both sides of the weld. Consequently, you end up with differing rates of expansion throughout the part, and then you end up with a crack on one side or the other of your weld. Cast material is very susceptible to this condition. Your best bet is to use pre and post heat. I hope I haven`t stepped on any toes, just offering my two cents. Check out this site. www.amweld.org/bb/technical/index.html
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|